19 Kitchen Tips On How To Get Rid Of Skin Tags

Skin tags are small soft noncancerous growth that can appear anywhere on the skin. Skin tags that are known scientifically as achrocordon can occur anywhere on the skin. It is a common occurrence in women as well as in men. These harmless looking little bumps can be unsightly hence it can make the person on whose skins they grow feel uncomfortable about their skin. In this article, we look at some of the main causes of this skin disorder as well as some symptoms to look out for. Then we will conclude by offering some tips on how to get rid of skin tags with ingredients found right in your kitchen

Causes of skin tags

Before struggling with different ways of getting rid of skin tags, it is important to understand what causes them. Skin tags are caused by the rubbing of skin against skin in parts of the body where the skin is thick. They often occur in places where there skin folds such as on the neck, the eyelids and around the armpit area. People who are prone to develop skin tags are those who suffer from; diabetes, problems of pimple outbreaks after shaving, pregnancy, excess of steroids and sometimes it can be simply hereditary. Once you know the cause of you’re the skin tag, you can now be in a position to find the right tip on how to get rid of skin tags suited for your particular situation.

Symptoms of skin tags

Not every raised bump that occurs on the body should leave you seeking for ways of getting rid of skin tags. You should be able to understand what the symptoms of skin tags before looking for how to get rid of a skin tag remedies. Most skin tags are irregular in shape, brown or black in color and appear in areas like the neck, eyelids, the chin, the breast and in the groin area. Skin tags are not painful.
Once people discover that skin tags are developing on parts of their body, they may become uncomfortable and try to reach out to a doctor. However, before even stepping out of your house, there are home remedies for how to get rid of skin tags that are found right inside your kitchen or somewhere else in your house.

1.Use onion juice

1
Soak onion in a salt solution and extract the juice the following morning. Apply this juice on the skin tag to remove it. This how to get rid of skin tags tip is very effective.

2.Use tea tree oil

2
Rub tea tree oil twice a day on the skin tag. Continue until it fall s off.

3.Use garlic

3
Apply freshly ground garlic to the tag at least two times a day

4.Use banana peelings

4
Cover a tag with the inside part of a banana peel. Keep the peel in place by placing gauzes over it. Repeating this over a couple of days will cause the tag to fall off.

5.Use ginger

5
For a very effective tip on how to get rid of skin tags, continuously rub ginger on the skin tag to permanently remove it.

6.Use potatoes

6
A slice of potatoes placed over the skin tag and held in place with a plaster or bandage will dry off the skin tags within days.

7.Use baking soda

Another effective tip on how to get rid of skin tags is to use baking powder. Make a paste of baking soda and castor oil. Apply this paste over the tag and leave it overnight. Continue doing this until you achieve expected results.

8.Use aloe Vera

7

A good tip on how to get rid of skin tags is to gently apply aloe Vera unto the tag and massage gently.

9.Use lemon

Soak cotton ball in lemon solution and apply over affected area. Repeat this until the tag falls off.

8

10.Use pineapple juice

Pineapple juice applied to a skin tag at least twice a day continuously for two weeks should get rid of it.

9

11.Use vegetable juice

A mixture of potatoes, garlic and cauliflower applied to the skin will do wonders for skin tags.

10

12.Use fenugreek

Soak fenugreek seeds overnight and drink the solution in the morning. This is one of the best remedies for getting rid of skin tags.

11

13.Use essential oils

Essential oils are known for their antiseptic powers and when it comes to skin tags, they are a great remedy. A mixture of essential oils should be great at removing skin tags. Make a mixture of basil oil, oregano oil and sesame oil ad apply to the area.

14.Use dandelion roots

When next you are asked the question how do you get rid of skin tag, advice the person to use dandelion roots. Juice made from the roots of dandelion is an effective remedy for skin tags.

12

15.Use thread to tie off the tag

Tie a thread tightly around the tag and cut it off after which you should apply an anti bacterial solution to it. This is one very common how to get rid of skin tags tip.

16.Use duct tape

If you are still asking the question how you get rid of skin tag after trying other remedies, try using duct tape over the tag. Leave the duct tape on for at least ten days. The tag will fall off on its own.

17.Use aspirin

Another tip on how to get rid of a skin tag is to dissolve and aspirin in water and use the solution to apply to the tag. The tag will eventually dry off and fall on its own.

18.Use apple cider vinegar

Apple cider vinegar is said to be the best treatment for home tips on how to get rid of skin tags. By soak a cotton ball in apple cider vinegar and placing the soaked cotton over the tag, it will eventually fall off permanently. This should be done for at least a month to get the best results.

13

19.Apply nail polish

14
Although this may not be found in your kitchen, it is a very good tip on how to get rid of skin tags. Cover the skin tag with nail polish and allow it to dry. Do this continuously and the tag will fall off.

About Admin@

One comment

  1. Introduction:
    Wastes of a solid nature needs to be discharged and disposed such that it will not harm the environment or people’s health. The Omani government therefore constructs landfills to avoid disease separation, insects accumulation and groundwater contamination. The aim of the landfill is for the disposal of waste which is not combusted for energy recovery, reused or recycled. The construction of the landfill and its operation is carried out based on the regulations of Omani to reduce solid waste effect on the environment.
    A visit to the site of the Al Amerat Sanitary Landfill in the area of Al Mutaqaa was carried out on April 1. The site visit was intended to know and gather data on the operation and construction of the landfill as well as gain knowledge on the process of waste separation and collection.

    Information on geography and history
    The first Omani landfill, which is located in Al Mutaqaa Area, is the Al Amerat Sanitary Landfill. The operation of the sanitary landfill is the responsibility of the Sita and Al Basheer Environment LCC. The operation of the landfill began on February 2011 with the site area covering more than 9.6 hectares, solid waste capacity of 1 million m3 and 5 cells. Every cell have 16 shafts that control the leachate. Leachate pump are linked to this shaft so as to aid movement in the leachate. This is one of the initiatives of government in solid waste management in municipals to create a friendly environment.

    Specifications for details and designs of engineering
    For land authority assurance:
    • Regularly monitored groundwater boreholes
    • Control of Third party construction activities
    • Initial geological and survey by the hydrogeological environmental.
    Several properly designed engineering design were implemented in the landfill. For the land fill in Al Amart, the modified high rise technique was adopted. There were also many methods of modification that were applied so as to minimize the formation of leachate as well as cost reduction and needs for material cove as well as the site life time increment.
    The initial process for the high rise technique is waste gathering followed by waste layer compaction on the surface of the floor. After the covering of every layer, a pyramid is formed by placing layers over each other. Due to the slope, there are less waste in the upper layer. The advantage of this technique is that a restricted area of land is needed leading to a reduction in pollution. Furthermore, the technique is applied in coastal areas and areas with high water table.
    Specifications of the Al Amarat Area
    • Systems of ventilations which has well and channels control the site of the released gas.
    • Network is used to monitor the groundwater.
    • Fluid is drained from the site through a drainage system.
    • The site layers do not allow water to pass through.
    • The waste is covered with inorganic soil.
    • The flood plains and valleys are not close to the site.
    • To avoid car accidents as a result of gathering of birds, the site is not located close to air traffic lines.
    • The site is also not located close to residential and sensitive areas.

    Diagram of the skeletal flow of the facility

    Figure 1: Diagram of facility flow “presentation of site visit”

    Waste composition and sources
    Table 1: Waste composition and sources
    Type Sources Composition
    Institutional Government centers, prisons, hospitals, schools Hazardous wastes, special wastes, metals, glass, food wastes, wood, plastics, cardboard, paper
    Commercial Office buildings, markets, restaurants, hotels, stores, etc Hazardous wastes, special wastes, metals, glass, food wastes, wood, plastics, cardboard, paper
    Residential Multifamily and single dwellings Household hazardous wastes, special wastes (such as tires, oil, batteries, white goods, consumer electronics bulky items), ashes, metals, glass, wood, yard wastes, leather, textiles, plastics, cardboard, paper, food wastes
    Industry waste Power plant
    Factories Metals, plastics, rubber, food, etc.
    Construction and demolition waste Demolition site Construction materials such as metals, masonry, bricks and pipes amongst others
    Composite waste Stores or market
    Institutions
    Restaurants
    Household Fabrics and plastics
    Ash waste Stores or markets
    Institutions
    Restaurants
    Household Remains of fine (cooking and heating)
    Site incineration
    Rubbish waste Stores or markets
    Institutions
    Restaurants
    Households Food serving and preparation
    Cooking
    Food waste Power plant
    Factories Metal scraps
    Waste from food processing


    Systems for collection of Waste
    Collection and separation of wastes need to be managed, from where they are produced, so that recyclable and reusable materials can be discovered.
    At Al Amerat landfill, the initial process is waste collection where waste of about 900 thousand tons is delivered at the landfill. The waste is compacted to a 30 m height in the first cell.
    The landfill uses the Hauled container system (HCS). The container is subsequently transported to the site of disposal, where it offloads the waste and returns to its initial position.


    Maintenance and operation
    The various composition of waste are gathered in the landfill including food waste, bottles, plastic, papers, etc. This is the process of operating the landfill:
    • The solid waste from the municipal is not combined with the hazardous waste.
    • The amount of waste gotten is weighed in the truck with the aid of the weighing scale.
    • For the sake of hygiene, the tires of the trucks are cleaned by machine.
    • Rain water is prevented from getting into the waste by using a plastic sheet to cover the final layer. The plastic sheet also gives a neat look.
    • To avoid bad smell, rainwater is stopped from getting into the waste by using plastic cover or soil to cover each of the waste’s layer.
    • 2 compactors are used to compress the waste. Every layer is compressed at least 3 times to 20 cm.
    • For secondary waste regulation, the contents of the truck are removed.
    • For primary control of waste, 140 trucks, carrying waste gets to the landfill and their contents are weighed.

    Figure 3: Area of landfill (Anon, 2010)

    Control and generation of gas and Leachate
    Gas and leachate are environment hazards which cannot be seen with the eyes. Leachate can lead to ground water contamination, as it is a liquid that forms the disposed layers of waste. Methane and other landfill gas is created by waste decomposition. Explosions and fire can be started in close structures as a result of methane, which is a combustible gas. Leachate on the other hand can lead to death of fish, drinking water contamination and poisoning of lakes. Gas and leachates thus requires monitoring to prevent pollution of the environment.
    Monitoring of environment
    There exist many systems for monitoring and regulating the locations where solid wastes are dumped as well as leachate, landfill gas and groundwater in Al Amerat.
    Monitoring of groundwater: The available holes are used to monitor the groundwater’s water quality. Bi-annually, the water is checked through a sample, which is tested to check how safe the water is.
    Monitoring of landfill gas (LFG): The system for extracting LFG from wells of gas is present to test the gas in the landfill. The system for extraction is optimized for the best results.

    Monitoring of leachate: a leachate sample is carried to leachate plant treatments to test its results.
    Extant issues and enhancing solutions
    Many issues exist that were created when the landfill was being designed and operated. Solutions are being implemented to minimize the problems’ effect on health and environment.

    1. Leachate
    Issue
    – Groundwater can be contaminated with leachate, which is a form of liquid that moves through layers of wastes in the landfill.
    Solutions
    – Regularly testing samples of leachates in the treatment plants.
    – Leachate transfer into the groundwater is prevented by placing at the landfill’s bottom layer, a landfill liner.
    2. Pollution
    Issue
    – Combustible methane gas is produced by organic waste.
    Solutions
    – Landfill constructed with high rise technique.
    3. Dust
    issue
    – Compression and excavation of soil leads to the production of soil. This creates medical issues including asthma and infection.
    Solutions
    – Dust spread is prevented with the aid of plastic sheets used to cover the solid wastes.
    – Workers are given face masks.
    4. Fire:
    Issue:
    – Materials combustion can result to fire, which would be hazardous in the landfill.
    Solutions
    – The landfill does not accept materials that are inflammable.
    – Build-up of gas is allowed
    Technical data
    • Opens between 6:00am and 6:00pm
    • Actual quantity of more than 800 Tons daily (7 days of the week)
    • Expected 250,000 tons every year
    • Lifetime expectation of 4 years
    • Started operation in February 2011
    • Volume of 1,000,000 m3
    • Constructed in 2005.
    Machinery
    • 2 buses
    • 2 pick up
    • 1 tanker 20m3 (Renault Premium)
    • 2 hook lift (Renault Premium)
    • 1 Excavator
    • 1 track loader
    • 1 Bulldozer
    • 2 Compactors
    Conclusion
    The landfill in Al Amerat is Omani’s first landfill that aids in the reduction of health hazard and pollution in the environment. The landfill features a great designed and is a good proof of the efforts of the government of Omani in reducing solid waste. Furthermore, Oman’s solid waste management can be enhanced by more people education and awareness. Lastly, the visit to the site was enlightening and it was in line with the module’s objective.

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>